Nokia Car Kit CK-200

Page 43
background image
I n s t a l l a t i o n
43
• The blue wire to the Ignition or ACC (accessory) line. Always 
connect the supplied 1 A fuse to this line, close to the source.
• The yellow wire to the car radio mute input.
2. Connect the direct input cable CA-161 to the respective connectors 
on the car radio and the junction box.
3. Connect the display to the respective connector on the junction box.
In some cars, you may need to switch on the car radio to hear the call 
audio.
Optional steps:
• To charge a compatible mobile device through the car kit, connect a 
compatible charging cable (such as Nokia CA-134) to the junction 
box.
• To use an optional external microphone (such as Nokia MP-2) 
instead of the built-in one, connect the microphone to the respective 
connector on the junction box, and modify the microphone settings 
(see “Installer settings”, p. 43). You may need to use an external 
microphone in noisy car environments.
■ Installer settings
The installer settings should only be modified by a qualified service 
technician.
In standby mode, press and hold the power key for about 10 seconds, 
and select from the following:
•
DSP settings
—
Select the set of audio settings that suits best. To 
activate the new settings, you may need to switch the car kit off and 
back on.
•
Microphone settings
—
Select the internal or external microphone 
according to the installation setup.
Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 Page 25 Page 26 Page 27 Page 28 Page 29 Page 30 Page 31 Page 32 Page 33 Page 34 Page 35 Page 36 Page 37 Page 38 Page 39 Page 40 Page 41 Page 42 Page 43 Page 44 Page 45 Page 46 Page 47