Nokia 9500 Communicator

Page 9
background image
Tip: If you have inserted the battery, but the device does not start up, press the power key.
Charging the battery
1. Connect the charger to an AC wall outlet.
2. Connect the power cord to the bottom of the device. 
scrolling. If the battery is totally discharged, it may take a few minutes before the charging indicator is shown.
The device can be used while charging.
3. When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device and then from the AC outlet.
When the battery charge level is too low for operation, the device switches itself off. If the cover phone switches off, the
communicator interface may still be active for a while.
Switching the device on and off
1. To switch the device on, press and hold the power key.
2. If the device asks for a PIN or security code, enter the code, and press 
OK
.
3. To switch the device off, press and hold the power key.
Tip: When you switch the phone on, it may recognize the SIM card provider and configure the correct text message,
multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings.
The communicator interface starts up first after the battery is inserted. You cannot switch on the cover phone immediately after
the battery has been inserted, you must wait until the communicator interface has started.
Tip: If you have inserted the battery, but the device does not start up, press the power key.
The communicator interface can be used without the phone functions when a SIM card is not inserted or when the 
Offline
 profile
is selected.
Radios
Your device has a separate GSM radio and wireless LAN radio. Switching off the device by pressing the power key on the device
cover switches off both radios.
Note, however, that switching off the device or using the offline profile does not prevent you from establishing a new wireless
LAN connection. Therefore, remember to comply with any applicable safety requirements when establishing and using a wireless
LAN connection.
Antennas
Your device has two internal antennas.
Note:  As with any other radio transmitting device, do not touch either of the antennas unnecessarily when the device
is switched on. Contact with the antenna affects call quality and may cause the device to operate at a higher power
level than otherwise needed. Not touching the antenna area during a phone call optimises the antenna performance
and the talktime of your device.
G e t t i n g   s t a r t e d
Copyright © 2004-2005 Nokia. All Rights Reserved.
9
Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 Page 25 Page 26 Page 27 Page 28 Page 29 Page 30 Page 31 Page 32 Page 33 Page 34 Page 35 Page 36 Page 37 Page 38 Page 39 Page 40 Page 41 Page 42 Page 43 Page 44 Page 45 Page 46 Page 47 Page 48 Page 49 Page 50 Page 51 Page 52 Page 53 Page 54 Page 55 Page 56 Page 57 Page 58 Page 59 Page 60 Page 61 Page 62 Page 63 Page 64 Page 65 Page 66 Page 67 Page 68 Page 69 Page 70 Page 71 Page 72 Page 73 Page 74 Page 75 Page 76 Page 77 Page 78 Page 79 Page 80 Page 81 Page 82 Page 83 Page 84 Page 85 Page 86 Page 87 Page 88 Page 89 Page 90 Page 91 Page 92 Page 93 Page 94 Page 95 Page 96 Page 97 Page 98 Page 99 Page 100 Page 101 Page 102 Page 103 Page 104 Page 105 Page 106 Page 107 Page 108